Running the Installer

To install Service Manager:

1. Run the installer on the server or servers that host the following SBM components:
   • SBM Application Engine
   • SBM Application Repository
   • SBM Common Services
   Note: If these SBM components are installed separately, you must run the installer on each server.
   The "Welcome to the Install Wizard" message appears. Click Next to continue.
2. Accept the license agreement. Click Next to continue.
3. Choose the installation directory. This directory temporarily stores files before they are copied into the appropriate folders inside the SBM installation directory for use by the SBM Server.
   Note: You cannot choose to install in the same directory as your existing SBM installation.
   Click Next to continue.
4. The installer detects which SBM components are currently installed on the server. A message appears if any of the required SBM components are not detected on the server. Click Install to install Service Manager.

5. Allow the install to complete, and then click Configure to launch SBM Configurator. For details, see Configuring Serena Service Manager.