Administration → Secure Socket Layer (SSL) Configuration → Configuring Mutual Authentication Mode → Property Settings for Mutual Authentication

Property Settings for Mutual Authentication

Before you can configure mutual authentication between a server and agents, or between a server, agent relay, and agents, you must set the following properties.

Table 1. Property Settings Required Before Exchanging Keys table
Property Location Value
If not set during install: server.mutual_auth In the server installation directory's installed.properties file; for example: .microfocus\da\conf\server\installed.properties true
server.jms.mutualAuth In the server installation directory's installed.properties file; for example: .microfocus\da\conf\server\installed.properties true
For each agent:

locked/agent.mutual_auth

 In the agent installation directory's installed.properties file: [agent_installdir]\conf\agent\installed.properties true
For each agent relay:

agentrelay.jms_proxy.secure

 In the agent relay installation directory's agentrelay.properties file: [agentrelay_installdir]\conf\agentrelay.properties true
For each agent relay:

agentrelay.jms_proxy.mutualAuth

 In the agent relay installation directory's agentrelay.properties file: [agentrelay_installdir]\conf\agentrelay.properties true

Copyright © 2011–2017 Serena Software, Inc. All rights reserved.