Add properties to a component for information that may have values specific to that component. A component property value would override the value for the same-named property at the application level.
To add a property to the selected component:
- Navigate to Management > Component > [select component].
- Select the Details tab.
- In the selection box, select Properties.
-
To set a single property, click the
Add Property (
) button.
-
Fill in the fields as shown in the following table.
Field Description Name Property name Description Property description Secure Select this if the property should be secure. Secure properties are stored encrypted and displayed obscured in the Deployment Automation user interface.
Value Value for the property that will be used by steps in a process
-
Fill in the fields as shown in the following table.
-
To set multiple properties, click the
Batch Edit (BE) button.
-
In the Properties box, enter multiple properties and their values on separate lines
as property=value.
For example, if you had properties host and port, you would enter them as follows:
host=myServer
port=8080
Note:The following restrictions apply to batch edit:
- The Secure option cannot be set.
- The value cannot contain the "=" symbol.
-
In the Properties box, enter multiple properties and their values on separate lines
as property=value.
- Click Save.
To use the property in a process, reference it when you configure a step that uses it. Use the following syntax: ${p:component/<property name>}