Management → Managing Components → Component Processes → Component Process Step Details → Using Switch Steps and Conditions in Processes
Every connection (except connections from the Start step) has a conditional flag. The conditional flag enables you to set a condition on a connection. The condition refers to the processing status of the originating step–success or failure. Possible flag conditions are:
The process completed successfully.
The process did not finish successfully.
Accept either status.
By default, all connections have the flag set to checked (true), meaning the originating step must successfully end processing before the target step starts processing.
To change a flag's value, cycle through possible values by clicking the flag.
A switch step is a utility step supplied by Deployment Automation that enables process branching based on the value of a property set on the step.
The following figure illustrates a switch step. In this case, the switch property is version.name. The connections from the switch step represent process branches dependent on the value of version.name. In this example, regardless of which branch is taken, the process will proceed to the Run WLDeploy step.
Run WLDeploy has success and fail conditions. See the Deployment Automation Plugins Guide for more information.
Switch steps are processed as follows:
C\:\\temp\\store
Copyright © 2011–2017 Serena Software, Inc. All rights reserved.