After you create the deployment path item, you are ready to design the
Tip: Typically, organizations should reuse environments and
deployment paths. The display is limited to 999 items.
To design the deployment path:
- In the deployment path item you just submitted, on the
Deployment Path tab, click
Edit Deployment Path.
- To edit a path that has already been activated, you must
first select the option to return it to construction.
- For the
Edit Deployment Path button to appear,
you may need to resize the window to a larger size.
Available Environments, click a connector in
the path at the position you want to add an environment or environment group
and then click the
+ on an environment box. The selected
connector is orange.
Note: You can filter available environments by name or to show only
environment groups or only environments. The view is limited to 60
- To remove an environment or environment group from the deployment
path, click the
x on the corresponding box within the path.
- To move an environment or environment group within the deployment
path, remove it, select the connector after which you want to add it, and add
it again in the new position.
- To configure an environment or environment group, click the
corresponding box in the path. A form appears where you can set the following
Activating the Deployment Path
After you have completed the deployment path design and are ready for
the path to be used, click
Activate to make it active and available for
selection in release packages.
Updating the Deployment Path Design
To update the deployment path design, you must return the path to
construction. It cannot be updated if it is in use by any deployable release
trains or release packages.
Copyright © 2012–2017 Serena Software, Inc., a Micro Focus company. All rights reserved.