To install
Serena Release Control:
- Run the installer on the server or servers that host the following
SBM
components:
- SBM Application Engine
- SBM Application
Repository
- SBM Common Services
Note: If these
SBM
components are installed separately, you must run the installer on each server.
The "Welcome to the Install Wizard" message appears. Click
Next to continue.
- Accept the license agreement. Click
Next to continue.
- Choose the installation directory. This directory temporarily stores
files before they are copied into the appropriate folders inside the
SBM
installation directory for use by the
SBM Server.
Note: You cannot choose to install in the same directory as your
existing
SBM
installation.
Click
Next to continue.
- The installer detects which
SBM
components are currently installed on the server. A message appears if any of
the required
SBM
components are not detected on the server. Click
Install to proceed.
-
Allow the install to complete, and then click
Configure to launch
SBM Configurator.
For details, see
Applying Required Settings.
Copyright © 2012–2016 Serena Software, Inc. All rights reserved.